Installation

Installing your new auto cover is simple. To help with this, a "Front" tag is sewn on the inside of the cover so you can easily see which side is the front. Once you’ve identified the front of the cover, secure this area of the cover around the front bumper first, then pull the cover over the top of the vehicle and secure under the rear bumper last. If your custom cover has mirror pockets, be sure to place the cover over the side mirrors first before the ends of the cover are attached to the bumpers.

Feel free to reinforce the inside of your cover with duct tape for any areas that will be in direct contact with sharp places on your vehicle, such as a hood ornament. This ensures your auto cover will last as long as possible.

If your vehicle does not have an antenna that can be removed or retract flush with your vehicle, you can apply the adhesive-backed patch to where the antenna would hit the cover if it were installed and aligned properly. Then go ahead and punch a hole in the center of the patch with a sharp object so that your antenna now has a custom fit.

Removal:
The following procedure will make it easier to remove and install the cover whenever it is used:

- Release both ends of the cover from under the bumpers.
- Fold up both sides onto the top of the vehicle into a long pile approximately 2 feet (60 cm) wide.
- Start at the front of the vehicle and fold the cover in three foot (1 meter) folds from the front to the back.
- If you use the same procedure each time, you will find it only takes about a minute to install or to remove the cover.

The elastic at each end of the cover will keep it in place under all normal conditions. Use care in installing the cover on a car which has just been driven to be sure the material does not come in contact with hot exhaust pipes.